Forum Discussions (33,609)

Sort by: View

Discussions	Replies	Latest Activity
Paneling uv division problem I'm trying to align circles to panels, something that shouldn't be to complicated. however, for some reason theres a problem with the uv di… Started by Liam Morrow in Discussion	4	Feb 22, 2010 Reply by Liam Morrow
golf ball I am pretty new to grasshopper. ive only done a few tutorials, there is an effect i would like to achieve. perhaps someone here can advise… Started by David Horan in Discussion	0	Feb 22, 2010
Can grasshopper run as an indipendant process not the same ID as Rhino? I am not sure if this is possible but it really seems odd to me that grasshopper runs as the same process as rhino. It would be great if on… Started by Joel Putnam in Discussion	4	Feb 22, 2010 Reply by Joel Putnam
sweep gone nuts I seem to be unable to get sweep 1 / 2 to work in most cases. as you can see not error message or anything else but also no surface. can… Started by Claas Eicke Kuhnen in Discussion	6	Feb 22, 2010 Reply by to]
Tree Questions Hi everybody can anyone explain why in some function manipulatation of multiple data stream is done as multipule branches yet other just us… Started by Tamir Lavi in Discussion	1	Feb 22, 2010 Reply by taz
About Surfaces Dividing Hi everybody!I have tried to divide tree surfaces through a tree data. So I put the surfaces and domain into diffience paths, then import… Started by skywoolf in Discussion	2	Feb 22, 2010 Reply by skywoolf
GH does not want to utilize curves for loft / messes up order Hi Grasshopper gives me a hard problem to solve. I created curves via offset and move. I selected the right order. But Grasshopper does no… Started by Claas Eicke Kuhnen in Discussion	16	Feb 22, 2010 Reply by Claas Eicke Kuhnen
How to extract line from lofted surface? Hi, I have a question.I made a rotated tower and I want to triangulate the surface.I do not know which command should I use to generate the… Started by Seung chul,Song in Discussion	4	Feb 21, 2010 Reply by Seung chul,Song
Expression editor... Can someone explain the subtleties of how expressions are handled in the expression editor? I must be missing something obvious here. In… Started by Mitch Heynick in Discussion	3	Feb 21, 2010 Reply by Luis Fraguada
Component Output Change Wish. Hey DavidAfter seeng Taz's reply to this tread using dispach to gate which section of code is in use.http://www.grasshopper3d.com/forum/top… Started by Matt Gaydon in Discussion	0	Feb 21, 2010