January 2013 Blog Posts (26)

Matlab + Grasshopper

I’m writing this post as a response to this discussion and the comments for this video.  I’ll briefly explain what’s happening in this video and then go through all the steps that you need to connect grasshopper to Matlab for a simple problem.…

Hi All,

I am new to grasshopper.

Have been experimenting for a while, but this a complete unusual field to me.

I have created a hull surface with Orca and and created some frames inside the mirrored and joined hull.

Then I wanted to offset it with GH in order to have a material thickness in the hull.

Therefore I took one side of the hull surface and made the offset.

But now the frames (which worked fine before I refencered them to the offset instead…

Hi Everyone,

For those who are interested in a quick grasshopper routine that can essentially replace the need for a plugin like RhinoTerrain when creating topography from contour lines please see the attached files.

The resulting mesh topography is comparable with the mesh results generated from RhinoTerrain and can be done within…

For my PhD thesis I´m making a connectivity / accesibility test of a certain urban area streets.

i have a problem with the accesibility test, cause i need to know wich points of the grids have direct connections with the others, as the image example

Any idea, to how finally get a list with all the points and their direct accesibility…

Here's a link to couple of posts on how I was able to hook up TouchOSC (iPad) and Grasshopper with Arduino UNO to create some neat control over servos and GH geometry.

Check it out!

www.archi-lab.net/blog_post_23.html

www.archi-lab.net/blog_post_24.html

Thanks,

Konrad

hey everybody,

i mapped these curves onto a cylinder. By offsetting the curves i realized, that not all curves are closed.

this happens at the uv start point of the projected surface. 

how can i solve this problem?

best, patric

010213_surfacemap.gh…