Grasshopper

algorithmic modeling for Rhino

In this example, I have used a joystick to apply the loading on a composite plate.

Views: 384

Comment

You need to be a member of Grasshopper to add comments!

Comment by WT4 on December 2, 2009 at 5:42am
I did not have piezzos. I only had a joystick which updated the contents of a file depending on the motion of the joystick. the content of the file was then read in through the read file component in grasshopper

Regards
Comment by enrique soriano on December 1, 2009 at 7:09pm
gorgeous! playfully cool!
i can imagine you could had an array of piezos.. to apply the load.

anyway.. i'll ask this feature for xmas for my structures teacher..
Comment by Luis Fraguada on August 31, 2009 at 7:04am
Hello,
Yes I meant manufacturing of the plate...
Best,
Luis
Comment by WT4 on August 31, 2009 at 1:33am
Hi Luis

Hope this message gets through this time.
Thank you for your comments.
The joystick is communicating through the USB port.
Not sure what you mean about the physical production bit. Do you mean manufacture
of the composite plate?

Regards
Comment by Luis Fraguada on August 30, 2009 at 6:30am
Very nice interaction! Is the joystick communicating via Serial? How is this workflow integrated into physical production? Again, very nice!

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service