Grasshopper

algorithmic modeling for Rhino

Sweeping Curves

Can anybody tell me why is this component beahving like this. I'm trying to sweep along 2 curves an arc like section curve. But the component does not returna surface actually is empty.

thank you

Views: 224

Attachments:

Replies to This Discussion

Permalink Reply by diego on August 6, 2009 at 12:49pm
HI again Claudio, It's just the direction of the railcurves, the section curve has to be at the beginning of the rail curves, so flip add a flip curve component after each or the rail curves and it should work fine.

diego
Permalink Reply by Claudio on August 6, 2009 at 1:39pm
Ang again diego thank you very much you are right

cheers

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service