New version of Gridshell Components

Comment

Comment by Flavio Meireles Caffarello on June 15, 2013 at 11:12am

Hi, Alex

It is very nice plug-in, congratualations.
What do you think of a grid-shell with some holes. Is it possible? 

Comment by Francesco Ranaudo on April 27, 2013 at 12:36pm

thanks for your reply Alex.

however still nothing...there isn't the component group in the ribbon. :(

Comment by Alex Baalham on April 27, 2013 at 10:02am

Hi Francesco

I'm using these components in Rhino 5 64 bit with GH 0.9 now with no problems, although it took a little while to get working as the folders used for components is different to Rhino 4. Try putting the Gridshell Components GHA into the following folder: '<mapped drive>:\Users\<your user name>\AppData\Roaming\Grasshopper\Libraries

You can find your components folder by calling 'GrasshopperFolders' then 'cOmponents' from the command line.

Hope this works.

Comment by Francesco Ranaudo on April 15, 2013 at 12:53pm

sorry alex, but it doesn't work for me! Rhino 5 64bit...is it supported?

Thx!

Comment by Alex Baalham on November 9, 2012 at 12:15pm

Hi javier - good to hear you've got it working now. I haven't properly tested this with GH v 0.9.xx yet, so any feedback you have would be welcome.

Comment by javier zaratiegui on November 9, 2012 at 11:31am

my fault. my surface was trimmed. That is why I was having the problems.
Thanks for sharing, I will post pictures of my project soon

Comment by javier zaratiegui on November 9, 2012 at 11:16am

Hi! I like your gridshell components.

Does it work on latest Grasshopper? I am having trouble (index outside the array, almost all the time). I am using mm, untrim surface...can´t get it to work. 

Please, let me know if I should install older grasshopper or what else could it be.

Thanks