algorithmic modeling for Rhino
Hello everyone,
one more -probably not too smart- question.
There seems to be a limit on my fillet that I do not understand. The slider in my script can go further than this 5704, but the curve remains the same after that. The same happens with fillet distance.
Why can't I fillet these two lines with a bigger radius?
thanks! Anja
Tags:
there is a limit with this component which is for "filleting the sharp corners of a curve". The main issue here is cornerS if you have more than one corner to fillet each segment of the curve has to be able to cope with a fillet at the start and end of a segment therefore anything greater than half the length is going to fail.
If you want to over come this then there is a fillet at a parameter component where you specify the parameter of the corner you want this also come s with its only limitations though
Fillet will only work until the fillet hits the middle of one line. This also applies to Rhino fillets
Welcome to
Grasshopper
© 2024 Created by Scott Davidson. Powered by