Unroll

Replies to This Discussion

Permalink Reply by Pieter Segeren on September 30, 2011 at 2:38pm

Hmm, I just checked but it is working for me.
Could you upload (just some of) your cylinders so I can check again?

Permalink Reply by Gabrielle Sacknoff on October 3, 2011 at 10:06am

Pieter, sorry I didn't get a chance to reply on Friday, but it worked when I defined the u and v. Thanks!

Permalink Reply by Tudor Cosmatu on September 30, 2011 at 4:36pm

Hello,

 

try this as well http://www.grasshopper3d.com/forum/topics/unroll?xg_source=activity

• ‹ Previous
• 1
• 2
• Next ›
• Page