Triangulation with Paneling tools.

Replies to This Discussion

Permalink Reply by Chris Hanley on January 6, 2014 at 12:14pm

The reason you are only seeing "some" of the panels, is because of the value that is in the Pn input, (pattern string), of the ptMPanel component.

The current string is (0,0)(0,1)(1,1)(0,0).  This string tells the component which order to connect the points in the grid to create a panel.  One way to think about it is if you consider your grid to be made up of rectangles.  Each rectangle has a starting point, (let's say lower left), of 0,0.  The next point is (0,1), then (1,1), and finally closing back at (0,0).  This creates one triangle panel, (half of the rectangle).  

You can input more than one connection string.  (As shown in the image) .  Adding the connection string of (0,0)(1,0)(1,1)(0,0) will complete the other panel you are looking for. (input the strings into a panel, don't forget to change the panel to multi-line data).  

Hope that helps!

Permalink Reply by Kalil Sarraff on January 6, 2014 at 3:09pm

Thank you very much Chris!!!
I followed your advice but I think I did it longer...I had to create another ptMPanel component and to write the second string.