algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
Extracting discontinuity points in pairs along a curve. C# I would like to create four point surfaces by connecting consecutive points on two separate curves. In my attached example I've extracted f… Started by William Dunn in Discussion	23	Jul 15, 2016 Reply by William Dunn
Millipede Topological Optimization Hi everyone. I wanted to do a topological optimization, like in this example: http://www.grasshopper3d.com/video/topological-optimization-g… Started by Erik Pelicaen in Discussion	0	Jul 15, 2016
multithreading with python Hello world... Can anybody offer some advice regarding multithreading and using GH components with python? I read Steve Baer's post (here)… Started by dustin in Discussion	6	Jul 15, 2016 Reply by Giulio Piacentino
Minion Pro crashes font editor In developing a font selection component for Parrot which used the FontDialog I noticed that certain fonts, such as Minion Pro would crash… Started by David Mans in Errors, Bugs and Oversights	2	Jul 15, 2016 Reply by David Mans
Gyroid Box Structural Analysis Millipede Hello everyone. I am new in using Millipede and I wanted to do a structural analysis of a gyroid box. Could anyone check if I'm doing it ri… Started by Erik Pelicaen in Discussion	1	Jul 15, 2016 Reply by Erik Pelicaen
Clean an inward offset I am struggling to clean an inward offset. Unfortunately, my starting curves have filets which produce self-crossing curves after the inwar… Started by Olivier Suire in Discussion	5	Jul 15, 2016 Reply by ng5 Alex
ALGORYTHM SUPPORT Hello everyone , I need urgent support with an algorythm for calculating center of gravity.I work for a well known designer in Portugal and… Started by yegobora in Discussion	0	Jul 15, 2016
Autosve doesn't work anymore I just recognized after a critical shut down, that my Autosave Folder was completely empty. I re-installed grasshopper and tested the diffr… Started by Ramon in Discussion	0	Jul 15, 2016
Unable to install Grasshopper_0.9.56.0.rhi on Rhino5 Hi! I'm using Rhino 5.0 (5.1.20927.2230, 09/27/2012) on Windows 7 x64 and I'm trying to install the latest version of Grasshopper (0.9.56… Started by Rubén Bodewig in Discussion	20	Jul 14, 2016 Reply by Flora1.618
Project a Curve on to a Brep Component This question has been asked before but without any answers. Since I ran into this issue myself I ask again. I have assigned a Vector/Direc… Started by Oliver Hampel in Discussion	13	Jul 14, 2016 Reply by Oliver Hampel