Grasshopper

algorithmic modeling for Rhino

Project a Curve on to a Brep Component

This question has been asked before but without any answers. Since I ran into this issue myself I ask again.

I have assigned a Vector/Direction to input D, but the Component projects Curves to Both Directions. One to vector D and one another too vector -D. Is there a way to have the curve only project into a single direction.

The open curve in the image is the one that I don't want to be projected. Any ideas are appreciated...

Views: 2691

Replies to This Discussion

Permalink Reply by Oliver Hampel on July 14, 2016 at 2:03pm

noted... will comply on next post

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service