Grasshopper

algorithmic modeling for Rhino

Views: 564

Comment

You need to be a member of Grasshopper to add comments!

Comment by djordje on February 6, 2014 at 12:37pm

Thanks!

Comment by Robert Vier on February 6, 2014 at 12:17pm

djordje, there are 16 parameters: x,y,angle, inclination for each of the four cones

Comment by Robert Vier on February 6, 2014 at 12:17pm

daniel,

the last part shows the five objectives:

mass ... iteratively sizing cross sections to reach <100% utilization gives different steel mass for each parametrization, hence the mass is an indicator how effective the geometry itself is.

max displacement ... this goal should get the max deflection below l/300

distribution ... maximize the area between the support points

zoning ... minimize the number of supports that are placed outside the zones

diversity ... maximize uniqueness of each solution

Comment by Daniel Hambleton on February 6, 2014 at 6:15am

Very cool! 

How are you measuring the performance of the structure?

Comment by David Stasiuk on February 6, 2014 at 1:05am

This is so good on so many levels...really fantastic!

Comment by Ethan on February 5, 2014 at 8:54pm

amazing!

Comment by djordje on February 5, 2014 at 3:52pm

Fantastic!
The initial support inclination angle is chosen by user?

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service