Grasshopper

algorithmic modeling for Rhino

Surface Divide - Point List Order

I am working through the development of a geodesic structure using Chris Mealing's wonderful geodesic sphere geometry generator. I am relatively new to Rhino and Grasshopper so I am, no doubt, asking a very basic question.

I am trying to convert the order of the points on the surface from 5 separate lists to one continuous list. I have attached an image of the development of the Rhino and Grasshopper files. The problem is probably simple, but any help would be appreciated.

Views: 661

Attachments:

Replies to This Discussion

Permalink Reply by Ethan on April 11, 2015 at 9:23pm

flatten the list

Permalink Reply by Gregory D Thomson on April 11, 2015 at 9:34pm

Ethan,

Thanks! That's perfect.

Of course, as I was doing a bit more digging and found the solution as well, proving that as soon as one asks the simple question the answer will be found.

Cheers!

greg

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service