Grasshopper

algorithmic modeling for Rhino

How to lined up series of curves' starting points??

Hello

I just started using grasshopper.

I want to create smooth loft surface from series of open curves.

However, I find strange kink conditions on the surface always.

I guess it is because where each curve’s starting points are different, and I need to use “flip” in somehow.

It may be a simple problem, but I couldn’t find solution by myself yet.

I will be happy if anyone could give me an advice to solve this problem.

Best,

Views: 361

Replies to This Discussion

Permalink Reply by Andrew Heumann on March 4, 2013 at 2:38pm

if, as in your example, the curves run more or less parallel to one another, use the "flip" component, and provide a guide curve - it will try to flip the curves so that their direction is consistent with that guide curve.

Permalink Reply by Toma on March 4, 2013 at 5:19pm

Andrew

Thank you for your advice!

It works .

I didn't know the guid component.

Thank you again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service