Grasshopper

algorithmic modeling for Rhino

can't find center of top surface

With great help from the forum I have been working on a script that allows me to find the center point of each rooftop. Seems to have worked great with the exception of 3 volumes, and I'm not sure why? Is it because they're not square enough in shape? The point doesn't even need to be centralized really, but I'm surprised not to have any at all. Any pointers would be really helpful.

Thanks!

Views: 632

Attachments:

Replies to This Discussion

Permalink Reply by Reinier de Graaf on February 25, 2013 at 6:12am

I think you did find them, they're just not on top of your buildings due to do the shape of the buildings.

I've circled the points that will probably be the center points of the rooftops.

Permalink Reply by Dedackelzucht on February 25, 2013 at 6:13am

Hey Tash,

Aera is a mass propertie component and the area centroid can be outside of a given surface. Your file is working correct. If you are only up to any point you can use the populate geometrie component.

Best Regards

DeDackel

Attachments:
Permalink Reply by Tash Tash on February 25, 2013 at 6:20am

Reinier - thanks for that, I couldn't see them before. That eases some of the confusion!

DeDackel - that worked perfectly, thanks ever so much

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service