Grasshopper

algorithmic modeling for Rhino


I crate a curve and move a copy in the Z direction.and then i lofted the curves. after all i try to offset surfaces but i couldn't manage. :/

Views: 764

Replies to This Discussion

i think i create the vektor and it connected to "move". than it become two curves which are diffrent in Z axes. than i lofted tham and make a surface. the problem is started after i tried to offset this surface. "Offsetsurface" is not inherited somthing from surface source.
and also i found out that when i use multiple curves by exploding the orginal curves and make surfaces by using this curves i can offset the surfaces (and it also intersects each other like picture).
Attachments:
i found something to, when i make a polysurface which contains folding edges...
yep its about polysurfaces... is anybody know how we offset the polysurfaces
hey oguz emre bal,
i think you should first offset the curve, then loft them and then you can extrude them in z direction. Good luck
Attachments:
damn!!! i tried hours and found the problem... the curves doesnt exist in the same plane. thanks for replies:)

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service