Grasshopper

algorithmic modeling for Rhino

Extruding Parametric Profile along Curve/Rail

It seem so basic but i've been bashing my head with this one. I have created a definition for parametric IPE profile but i cannot extrude it along spline (it works as extrude linear & extrude along vector). If someone could check this out & explain some more... any solution would be much appreciated.

attached file is for GH_v0.6.0043

Views: 15812

Attachments:

Replies to This Discussion

Permalink Reply by martin on April 17, 2012 at 2:00pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service