I have a bunch of curves, about 60 of them. I would like to make a definition that I can enter in a Length and Width and have it select any of the curve's whose bounding box exceeds the Length and Width I entered.
I'm thinking that it shouldn't be that hard, I am just not good with working with lists.
Thanks for the quick reply. I think it is really close. Just doing some initial tests. It currently has to fail both the Length and Width parameter to work. I'd like for it to fail if any curve goes over the width or height, is that too much to add? If so I think I can figure it out with this as a starting point.
It is now giving all curves that exceeded both length and width at the same time. To change it to be either one or the other, then change the AND component to an OR.