Grasshopper

algorithmic modeling for Rhino

series question

Hello, I am just learning and very much appreciate the forums help!
I am trying to make a series that goes:
0,1
1,2
2,3
3,4
and so on until a specified end number...
Thanks -Ethan

Views: 354

Replies to This Discussion

Permalink Reply by Michael Pryor on October 22, 2011 at 5:35pm

use the series component. Input 1 as start number, 1 as steps between numbers, and whatever number for the number to end the list at. 

Permalink Reply by Ethan on October 22, 2011 at 6:13pm

I am looking for a solution like the one on the top of this image, but which does not require me to cut and past , can run till an end number and then could combine these lists into a list of lists. thanks

Permalink Reply by Ethan on October 22, 2011 at 6:37pm

figured it out thanks!!!

Permalink Reply by Chris Tietjen on October 22, 2011 at 6:48pm

Chris

Permalink Reply by Pieter Segeren on October 23, 2011 at 4:57am

Permalink Reply by Mateusz Zwierzycki on October 23, 2011 at 6:22am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service