Rhino Common Sweep1 Method

have the Miter arguments been dropped form the Rhino.Geometry.SweepOneRail class? I understand these arguments were availble pre rhinocommon. How does one create miters at the kinks of a polyline or joined curve?

thanks

Replies to This Discussion

Permalink Reply by Steve Baer on July 28, 2011 at 10:24am

I just haven't gotten around to adding these yet. I'll try to add some miter options this week.

-Steve

Permalink Reply by Steve Lewis on July 28, 2011 at 10:58am

Steve

thanks for the reply.

That would be awesome if you could find time for updating this! I hit a brick wall yesterday trying to find a way to miter my swept surface at kinks.

When you update rhinocommon how does that relate with the current build of grasshopper? Can I reference a new build of rhinocommon with an existing reference to grasshopper or do I have to wait until David also releases a new build of grasshopper with a reference to the updated rhinocomon build?

Thanks

Steve

Permalink Reply by Steve Baer on July 28, 2011 at 1:07pm

If you are using Rhino 5, then Grasshopper uses the build of RhinoCommon that ships with Rhino 5. This means that your miter addition will be available as soon as the next V5 Beta is released (typically every Tuesday)

If you are using Rhino 4, you need to wait for the next build of Grasshopper. Grasshopper uses a special build of RhinoCommon when it is loaded in Rhino 4.

Hope that makes sense. Oh and by the way, I've already added the miter code to RhinoCommon so it will be available in the next build.

Permalink Reply by Alexander on August 10, 2011 at 10:03pm

But it doesn't work in my latest Rhino 5(and grasshopper 08.0050)?

Attachments:

sw1_test.3dm, 93 KB
sw1_test.gh, 2 KB

Permalink Reply by Steve Lewis on September 8, 2011 at 10:53am

Did you get it to work yet?

Permalink Reply by Steve Lewis on August 30, 2011 at 4:34pm

Yes, i now see the miter option in build *51 of grasshopper, good job, thanks. Ill revise my code this after work and let you know if it works, thanks again

Permalink Reply by Steve Lewis on August 30, 2011 at 5:30pm

Hey steve, I have tried the miter option for various values of 0 1 and 2. It doesnt appear to do anything. I have tested it with a polyline.

Cheers

Permalink Reply by Steve Lewis on September 8, 2011 at 10:52am

Steve any news on this?

RSS