Grasshopper

algorithmic modeling for Rhino

Make an group of beams only work as a compressive or tensile profile

Hi there,

I was wondering how i can give data to a group of cross sections so that they can be defined as a compressive profile only or an tensile profile, for example wind shears.

Regards,

Giorgio

Views: 143

Replies to This Discussion

Permalink Reply by Karamba3D on December 20, 2018 at 11:28am

Hi Giorgio,

at the moment (Karamba3D 1.3.1) it is not possible to specify tension-only elements. As a work around you could try to use the 'Tension/Compression Eliminator'-component.

Best,

Clemens

Permalink Reply by Giorgio on January 4, 2019 at 12:38am

Thanks Clemens! I will test that out. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service