algorithmic modeling for Rhino
Hello,
I'm new to Grasshopper, and this is my first question here.
I am using a component called Radial Hex that works just like GH Radial, and would like to limit the pattern boundary to a circle curve that I have set.
I have been trying different ways to go about this, but not found a solution just yet and would like to ask this forum for some advice.
Many thanks!
Tags:
Thank you so much! This is exactly what I needed! :D
You could 'Explode' all the polylines and use 'InCurve' to make sure BOTH end points of each segment are within the circle (radial_2017Mar8a.gh):
Or you could check just the mid-point of each line segment, which returns lines that cross the circle (radial_2017Mar8b.gh).
Then you could 'Shatter' those lines that intersect the circle and ignore the parts outside the circle; I'll leave that part to you. ;-)
Thank you so much! I've learnt a bunch of new things thanks to your answer!
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by