Select Outbound UV in Subsurface

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 13, 2016 at 11:46am

Hi,

This could be a way, but not sure it would guarantee to reuse afterward for your additional requirements.

Attachments:

• crosshelp_re.gh, 23 KB

Permalink Reply by daniel assayag on September 13, 2016 at 12:01pm

I will use it to map surfaces into the trimmed surfaces.

Im amazed by your definition.

You even colored it  :=)

I dont understand it completely yet, but il will!

It really helps me to get better at grasshopper! 

Thank you so Very much

Permalink Reply by Deer on September 14, 2016 at 1:36am

I think Kim just post a perfect solution with 'collision' 

Maybe some of his components confused you, here is the simplified diagram below:

The below 2 way is suggested way because it is much faster.

Collision is a high dimension operation which is usually time consuming.

Permalink Reply by daniel assayag on September 14, 2016 at 9:38am

Hi Deer,

Can you post your definitions?

Thx for your help

Permalink Reply by Deer on September 14, 2016 at 11:13am

I am sorry that I deleted the source file after the screen capture. Did you have problems recognizing components icons? I will upload files in these 2 days.

Permalink Reply by daniel assayag on September 14, 2016 at 12:42pm

I just found the component i didnt know which was Discontinuity

Thanks ! It works very well!

Permalink Reply by daniel assayag on September 14, 2016 at 1:46pm

Could it be possible to use your technique to divide each continuous array separately like in the picture shown here?

Permalink Reply by Hyungsoo Kim on September 15, 2016 at 1:36am

Something like this?

Attachments:

• Division&Selection.gh, 14 KB

Permalink Reply by Deer on September 14, 2016 at 11:13pm

if you want to seperate with rims.
try group them with 'distance to the center'

Permalink Reply by Deer on September 15, 2016 at 1:41am

Kim just did everything for your.
I do think this is not so good for a beginner.
:-)