scanned complicated mesh to surface

Replies to This Discussion

Permalink Reply by jjl on July 18, 2016 at 12:20pm

Thanks! I think I will try simply it in other software and rebuild. I will let you know if I make any progress.

Permalink Reply by martyn hogg on July 18, 2016 at 7:03am

Have a look in Samples & Examples forum, Nik did something on this but not sure how well it will work on your mesh. You might need to simplify you mesh first so it doesn't take ages to process and then increase the mesh face count until you get the surface quality you need.

http://www.grasshopper3d.com/forum/topics/auto-nurbs-surfacing-of-m...

Permalink Reply by martyn hogg on July 18, 2016 at 3:44pm

I thought he was converting the mesh faces to surfaces but then blending them all into one surface?

Edit:

It does look like lots of patched surfaces, but he has at least smoothed them so you lose the faceting you get with a mesh so I'd question describing them as messy. Or even Meshy :)

Permalink Reply by jjl on July 18, 2016 at 12:20pm

Thanks a lot!