Grasshopper

algorithmic modeling for Rhino

Variating heights paramattrically

Hello all

I transported a curve from rhino into grasshopper and divided into multiple points. i made a parabolic curve on these points whose shape could be controlled by a graph mapper. i wanted to be able to variate the heights of the curves using a graph mapper. i was able to change the heights using an attractor point but can it be done paramatrically?

Everytime I tried to connect a graph mapper the same error would show that "failed conversion from number to vector".

Views: 612

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on April 18, 2016 at 2:50pm

Hello Natasha,

Where did you try to connect a graph mapper? The one you have on your definition works fine and doesn't give any errors.

Permalink Reply by Hyungsoo Kim on April 18, 2016 at 2:53pm

Hi.

In my opinion, you've forgotten two things.

1. Try to use "Range(Domain-->0to1)" instead of "Series"
2. Try to reparemeterize curve input of "Evalute Curve".

See red parts. And I've modified your def. a bit with attractor logic. Best.

Attachments:
Permalink Reply by Natasha Raheel on April 18, 2016 at 3:16pm

Thank you.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service