Extrusion and Isotrim

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 2, 2016 at 12:33pm

Hi.

I doubt the output geometries of "Extrude" are surfaces. they are more likely to be "Open Breps".

You can make sure by connecting panel component to the Extrude component's "E" output node and see what type of geometry name they have.

if, in case they are "Open Brep", you can use "Deconstruct Brep" after that(you can possibly get 4 surfaces per each floor), and finally connect "Isotrim".

Permalink Reply by Juan Carlos Rivera on February 2, 2016 at 3:31pm

Oh thank you so much! it worked with Deconstruct Brep. Thanksss