Grasshopper

algorithmic modeling for Rhino

Attractor Curves and Attractor Points with different forces

Hello I am new to GH and I have a problem with my thesis :/

I want to create a surface using attractor Curves and Attractor points while i have a height boundary and controlling the force of the two different points. I have tried many different ways doing that but in every case I couldn't use both attractor curves and points, or i couldn't control the force of the points, or I couldn't have boundaries for the new surface.

Is there a way to solve this problem and have a surface that is not too complex?

Thank you

Views: 955

Attachments:

Replies to This Discussion

I think you are not explaining clearly enough what you want to achieve, your GH definition is not self explanatory, could you include some images? or notes in the file? something to figure out what you are trying to achieve

I have downloaded Nudibranch and I am close to create the surface I want.

The only problem now is I want the new points to have a minimum and a maximum height.

And also is there a way to make a surface from these new points? Because the loft doesn't work.

Attachments:

Hi Dimitris,

refer to the attached.

three different ways to achieve the same result. Due to your initial surface being a trimmed one, you'll have to resort to meshes to achieve a unified geomtery.

Let me know if any questions. 

Ps. using Weaverbird and Kangaroo (+ nudibranch)

Ta,

M.

Attachments:

thank you!!

I will reconstruct the last one to create a surface instead of a mesh because I will need it later on. Thanks once again! :D

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service