Grasshopper

algorithmic modeling for Rhino

Sublist

Hi ,

How do i get to make 4 different separated list according to the result of the closest point found.

I have a list of surfaces that i would like to cross with a list of points with 4 specific indices in order to get 4 separated list of surfaces.

Thank you for your help on this very basic question.

Anjy

Views: 932

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on November 3, 2014 at 9:49am

Hello

check out the answer of machinehistories in the following thread

http://www.grasshopper3d.com/forum/topics/pattern-deformation?xg_so...

alex

Permalink Reply by Anjy78 on November 3, 2014 at 10:08am

thank you Alex

Permalink Reply by Anjy78 on November 3, 2014 at 1:28pm

I came up with this solution but I am not very satisfied with it.

Maybe there is another way?

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service