Grasshopper

algorithmic modeling for Rhino

Extrude Surfaces by a chosen amount when a certain distance from an attractor line

Hi there, 

I'm new to grasshopper and I am trying to extrude surfaces by chosen amounts in relation to their distance from an attractor line. 

If a surface is more than 50m away to extrude by 3m

If a surface is more than 100m away then extrude by 6m 

If a surface is more than 150m away then extrude by 9m

All relating the the attractor curve. I have done my best at setting this up. I think I might need to extrude the true values? 

I have attached my rhino file and grasshopper file.

Thanks in advance,

Tom

Views: 600

Attachments:

Replies to This Discussion

Permalink Reply by JS on March 11, 2014 at 5:37pm

Try this out. It's not the neatest way, but it gets the job done.

Attachments:
Permalink Reply by Thomas J Bestwick on March 12, 2014 at 10:26am

Wow! Thanks so much for your help. It means a lot to me! Tom

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service