Grasshopper

algorithmic modeling for Rhino

Using the plug-in "Anemone" by Mateusz Zwierzycki for grasshopper 3d, a loop is made to grow a non intersecting geometry from a simple box. It is then meshed with weaverbird.

Comment

You need to be a member of Grasshopper to add comments!

Join Grasshopper

Comment by Michael Pryor on January 5, 2014 at 9:41am

If is just a test, you can run a test in many ways without the word "if" for instance here I say "if geometry intersects itself then try again" But I do this with the component collision. You need to think in terms of components rather than words so much in grasshopper, Same thing but different look. There is however the evaluate component and logic gates.  

Comment by ali taherdoust on January 5, 2014 at 9:31am

tnx
do you know any plug-in for "IF"?

Comment by kao.gene on January 5, 2014 at 8:37am

ail: Michael use "Anemone" plugin, so you need to install it first. 

Comment by Michael Pryor on January 5, 2014 at 8:25am
???
Comment by ali taherdoust on January 5, 2014 at 6:56am

DO ?! excuse me i cant find DO commend or IF in any plug-in!!!
can you tell me? i really need them

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2014   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service