Grasshopper

algorithmic modeling for Rhino

Showing VSC over a grid

Hi everyone, 

I am trying to show the VSC (vertical sky component) over the facade of a building but turns out the output I get is 14 times bigger that the number of points in my grid, and therefore the "Ladybug re-color mesh" component fails to work. Does anyone know why is are the results larger than my grid and how could I make it work? 

Thanks!

Alejandro

Views: 652

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 1, 2014 at 10:03pm

Hi Alejandro,

Can you please attach the file here? It is really hard to say why it is happening by just looking to screen capture.

Also why are you connecting the output of Honeybee_Honeybee to runDaylighting component?

Mostapha

Permalink Reply by Alejandro Pacheco Diéguez on November 4, 2014 at 5:01am

Hi Mostapha, 

Here is the file. The honeybee/honeybee component was connected there by mistake, but I don't think it does anything connected there. 

Alejandro

Attachments:
Permalink Reply by Mostapha Sadeghipour Roudsari on November 5, 2014 at 11:46pm

Hi Alejandro,

You need to either join the mesh or unflatten the test points. Checked the attached file.

- Mostapha

Attachments:
Permalink Reply by Alejandro Pacheco Diéguez on November 7, 2014 at 8:24am

Excellent, It works, Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service