Grasshopper

algorithmic modeling for Rhino

Karamba Discussions (584)

← Back to Karamba
Discussions Replies Latest Activity

compression, tension and shear of a test material

I made a simple definition to corroborate the behavior of a test material under compression, tension and shear.  The motivation behind this…

Started by Diego Gil

4 Nov 21, 2012
Reply by Diego Gil

Minimum deflection using Galapagos vs Analyze large deformation

I was inspired by one question on General discussions section of the forum, about grid shell's form finding. What confused me is the differ…

Started by djordje

0 Nov 21, 2012

Shell view doesn't display any stresses results.

I'm trying to take a look on any of the stresses in my shell model but when I try to do so the ShellView turns out red and doesn't generate…

Started by Rafael Pastrana

4 Nov 20, 2012
Reply by Rafael Pastrana

Supports trouble on model assembly

Hello everyone, can anybody help me to figure out how to plug more than one support in the assemble box? At this time I'm unable and I want…

Started by Rafael Pastrana

3 Nov 18, 2012
Reply by Rafael Pastrana

my id modelview works on the displacement, but not on the princ stress

Hello, I only want to see the stress results in the top of my shell structure. I splitt the mesh in 2 ID`s, when i want to view only one I…

Started by j koeken

2 Nov 13, 2012
Reply by j koeken

Karamba principal stresses are not correct

Hello The result of my Karamba calculation does not match whit the results of my final element program DIANA, i know the results in DIANA a…

Started by j koeken

12 Nov 12, 2012
Reply by karamba

Thickniss shell structure

Hello, I want to increase the shell thickniss of a structure when i`m reaching the supports   is this possible?   Regards,   Jeroen

Started by j koeken

9 Nov 9, 2012
Reply by Robert Vier

Galapagos optimalisation

Hello, Galapagos is now working at my optimalisation of my shell structure, does anyone know how to fix this problem? See the attached gh.…

Started by j koeken

1 Nov 1, 2012
Reply by j koeken

Optimization Of Trusses Utilising Genetic Algorithms

I wish to look into Multi objective Optimization of trusses; such as weight-cost Optimisation (fabrication cost included weld lengths, asse…

Started by Kane Borg

2 Oct 31, 2012
Reply by Diego Gil

weird behaviour of shell elements

Hi, in order to check out the new shell elements, I created a simple geometry: rectangular plate, support at the corners, uniform load. Th…

Started by Stefan

7 Oct 30, 2012
Reply by Robert Vier

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service