Grasshopper

algorithmic modeling for Rhino

Karamba Discussions (535)

← Back to Karamba
Discussions Replies Latest Activity

HOW TO ADD A SUPPORT IN THE MIDDLE OF THE BEAM

HI If i want to add a support in the middle of the beam, i dont know how does it works.

Started by CHILEMENI

2 Jan 18
Reply by CHILEMENI

Providing memeber cross section in karamba and comparison of modelled results with actual strucutre.

Hello, This is my first educational project on Karamba, therefore some questions are very basic so please pardon me for that. 1. I am work…

Started by Anand Shah

0 Jan 15

Providng scissor type hinge joints in Karamba between continous memebrs

Hello, I am very new to Karamba. I am working on design and analysis of a timber gridshell using Kangaroo and Karamba. I need to provide sc…

Started by Anand Shah

4 Jan 15
Reply by Anand Shah

2 models as output problem of “analyzethl” Karamba component

Hi,I am using Karamba for a structural check of a shell. I used a Kangaroo for the form-finding and then Karamba and in the output of the a…

Started by Marinella Contestabile

0 Jan 14

Point load placement in Karamba

Hi For a simple test, i applied point loads to a simple 'tent' structure. I've put a list of the points into the 'Loads'-element, but if I…

Started by Reinout van Arnhem

1 Jan 9
Reply by karamba

Analyze solids

Hi, A few friends and I, recently started modelling a bench made out of concrete (GRFC concrete). The legs of the bench are circular and an…

Started by Tsvetan Donov

1 Jan 8
Reply by karamba

Beam Optimization

Hi, I am new to Karamba and Grasshopper, so I am basically copying all tutorials I can find on youtube. I did a simple cantilever beam with…

Started by Tsvetan Donov

2 Jan 8
Reply by Tsvetan Donov

Shell Analysis

Hi all, I've been trying to analyze a shell but i am not sure about the load condition, because i wanted to give a uniform load to the whol…

Started by Davide Rando

1 Dec 22, 2017
Reply by Joseph Beard

material utilization - mesh resolution + model view

Hello, I am working on a model of concrete building containing of slabs (shells) + columns and beams (beams). I have two questions regardin…

Started by Wujo

2 Dec 20, 2017
Reply by karamba

Cantilever element

Hi Could you help me please; I have a doubt about my modeling. I have element in aluminum recessed on one side and loaded on the other. I…

Started by sandra

1 Dec 19, 2017
Reply by karamba

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service