Voxelize

I'm trying to make a stepped voxelise pattern on my 3D model but the pattern isn't covering the whole building. any suggestions how I can fix this so the pattern covers my whole building. I'm a complete grasshopper novice and am totally confused by the script i am using.

Replies to This Discussion

Permalink Reply by djordje on May 12, 2013 at 5:26pm

Hi Alireza,

Use this definition:

https://www.box.com/s/nnpnyjichalrpi8wuq95

Check the article on definition info:

http://complexgeometry.com/2013/02/06/pixelization

Permalink Reply by Mateusz Zwierzycki on May 12, 2013 at 5:47pm

The "Voxel" component included here http://www.grasshopper3d.com/group/milkbox/forum/topics/mesh-pipe-a... will generate the voxels much faster (the one linked by djordje takes 3 minutes to compute this mario figure, the "Voxel" would prolly make it under a second). It is because operates on mesh geometry, you only need to supply it with points. It will automatically "merge" all adjacent faces, but you can omit that merging by grafting the input list.

RSS