algorithmic modeling for Rhino


i'm new and an absolut beginner of grasshopper.

is it possible to remove all the Points with the x- and y- coordinate 0,y or x,0.

grasshopper should not begin with Zero... 

For help, I would be grateful

Views: 91


Reply to This

Replies to This Discussion

Yup, you test whether the X and Y coordinates are small enough (i.e. close to zero), and if both is the case you do not include the point in a Cull Pattern component.

In fact going the other way around is more practical, you only include the point if both the X and the Y are significantly bigger than zero.


Didnt knew it is possible to use the expression like thisthats really nice!

thank you David, it works.



Search Grasshopper


  • Add Photos
  • View All

© 2017   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service