Grasshopper

algorithmic modeling for Rhino

i am trying to map lines and curves into surface using the SrfMap Tool 

but the curves and lines are not mapped into the surface , it keep being straight and out of the surface 

Views: 88

Reply to This

Replies to This Discussion

That's the correct behavior of the component, afaik. As it says in the description, it will map the curves control points. In your case if you are trying to map line, only the start and end points will be on the surface, the connecting segment will still be straight.

What you are looking for is the "surface morph" component. Also, make sure its a nurbs curve object.

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

© 2014   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service