Grasshopper

algorithmic modeling for Rhino

modeling laser cut tension fabric in rhino 4 w/ GH

Hello,

I've been trying to create a laser cut fabric canopy in Rhino 4.  I want the the final to be similar to the following link with
pierce cuts but not large holes so that the fabric will drape off of
the main surface.

http://farm4.static.flickr.com/3463/3386233844_56fa63a6a1.jpg

I'm trying to learn grasshopper to try to achieve this. While I can easily create the cut paths on a flat surface and send it to the laser cutter,
I have not been able to achieve the full draped effect in rhino.   I
need to create a 3d model to show my client before an actual sample is
made.

Any suggestions??

Views: 1990

Replies to This Discussion

Permalink Reply by taz on March 10, 2010 at 9:48am
Generating the forms and generating the 2D cut curves are two separate problems.

Here are some suggestions for cloth modeling, but it's not easily done with GH alone: Heinz Isler
Permalink Reply by taz on March 10, 2010 at 10:20am
If you're looking to model "gills" here's a file I made that works with an attractor point.

Attachments:
Permalink Reply by Megan Ashley on March 10, 2010 at 10:23am
Thanks! I'm looking to model a version of smaller "gills" on a large fabric canopy. I'll see if I can make this work.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service