Measure angles sorting lists correctly

Replies to This Discussion

Permalink Reply by peter fotiadis on February 10, 2016 at 6:40am

Have some fun with this attached > is this what you are after?

PS: Used a little code for the Ray shoot part (but check the disabled native GH component as well). I was ready to do all the job via code as well ... but then I said to myself > WHAT are you doing you #%$%$ idiot? > thus >  get the White Side option, he he.

PS: See notes about the nodes inclusion in the ccx Events.

Attachments:

• Ray_shoot_V1.gh, 147 KB

Permalink Reply by peter fotiadis on February 10, 2016 at 11:01am

Spend a couple of minutes more on that one > added some visual "help" more  in order to guide you into the unknown: all these mcc things are mysterious/ominous ... and what these freaky indices mean? you tell me, he he,

Attachments:

• Ray_shoot_V1A.gh, 147 KB

Permalink Reply by Pilar on February 11, 2016 at 3:57pm

Hi Peter! Thank you very much! Sorry for my late response, but it took me some time to understand your gh completely. Although those weren´t exactly the angles I needed to measure, the process was what I needed to do.

Thanks again for your time!!!!

Pilar

Permalink Reply by peter fotiadis on February 11, 2016 at 11:11pm

You want to perform a ray shoot inside a region right? (circle [i.e. a sphere actually] is used for simplicity: just add Z to the shoot point and enjoy the "chaos" ... but don't expect many ccx Events).

If yes  - and in case that there's still issues pending - what are exactly the angles that you are after?

Permalink Reply by Pilar on February 15, 2016 at 6:04am

This lines are mapping paths, so the angles I wanted were the ones produced between the main lines and the secondary lines.

Thanks again peter!