Grasshopper

algorithmic modeling for Rhino

How to Sweep or Loft these two curves?

Hi there,

I´ve been trying around to make a surface from the two curves shown in the attachment. But no chance for me, I can´t get it working...
Both curves are flattened (no paths)
I tried Sweep1, I even shattered curve_01 in two pieces to try with two halfs.
Nothings worked properly.

Is there a solution?

Thanks anyone!

Views: 1296

Attachments:

Replies to This Discussion

Permalink Reply by gt2p on July 6, 2009 at 6:37pm
hey h8 test this patch, if you change de crv in put please press rebuild solution.
Attachments:
Permalink Reply by Vicente Soler on July 7, 2009 at 12:17pm
I simple loft should work fine if you have the bottom curve split in 2. Remember to select the curves in the right order, maybe you need to flip one of the curve's direction.

Permalink Reply by h8cru on July 8, 2009 at 4:55am
Thanks, I tried this before.
Unfortunately I don´t know how to flip the direction of curves...
Would you please give a hint?

Thanks!
Permalink Reply by Dirk Anderson on July 8, 2009 at 5:16am
Use the Curve > Util > Flip Component
or... just flip in Rhino (Type 'Dir' and click on curve)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service