Grasshopper

algorithmic modeling for Rhino

3d voronoi louver

3d voronoi louver

re-creating old project. 3d voronoi structure, outside faces grouped then culled out larger outside faces based on area function. those faces then have a simple louver system applied (following local now world ucs)

Views: 461

View Full Size

Comment

You need to be a member of Grasshopper to add comments!

Comment by Aaron Coffman on December 19, 2011 at 9:01am

oh sorry about that...you can find it here:   http://www.grasshopper3d.com/forum/topics/cull-outside-faces

Comment by Michael Pryor on December 19, 2011 at 8:20am

no i mean, what did you use to cull the boarder faces?

Comment by Aaron Coffman on December 18, 2011 at 8:05pm

i culled out all the faces that were on the very outside of the 3d voronoi bounding box.  from there i then culled out those faces based on a function of their area (if they were less than a specific area they were removed)

Comment by Michael Pryor on December 18, 2011 at 5:54pm

what list face solution did you use?

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service