EC
1. Between hours 1:00 to 24:002. Current document units is in Meters3. Conversion to Meters will be applied = 1.0004. [1 of 7] Writing simulation parameters...5. [2 of 6] No context surfaces...6. [3 of 6] Writing geometry...7. [4 of 6] Writing materials and constructions...8. [5 of 7] Writing schedules...9. [6 of 7] Writing loads and ideal air system...10. [7 of 7] Writing outputs...11. ...... idf file is successfully written to : c:\ladybug\Freeformtower_IDF\EnergyPlus\Freeformtower_IDF.idf12. 13. Analysis is running!...14. ......
Done! Read below for errors and warnings:
15. 16. Program Version,EnergyPlus-Windows-64 8.1.0.009, YMD=2015.04.04 23:39,IDD_Version 8.1.0.00917. 18. ************* IDF Context for following error/warning message:19. 20. ************* Note -- lines truncated at 300 characters, if necessary...21. 22. ************* 577 Zone,23. 24. ************* Only last 1 lines before error line shown.....25. 26. ************* 578 Freeformbuilding27. 28. ** Warning ** IP: IDF line~578 Comma being inserted after:" Freeformbuilding" in Object=ZONE29. 30. ** Severe ** Out of range value Numeric Field#5 (Type), value=0.00000, range={>=1 and <=1}, in ZONE=FREEFORMBUILDING31. 32. ************* IDF Context for following error/warning message:33. 34. ************* Note -- lines truncated at 300 characters, if necessary...35. 36. ************* 586 BuildingSurface:Detailed,7341.
…
ggle A
7. Toggle A
8. Toggle 2
9. Toggle 3
10. Toggle A
11. Toggle A
12. Toggle 3
I was thinking to use somehow slider and animate option....but without luck
Any idea would be appreciated…
5 8, and then the following values are obtain as the last one (8) plus 3, then this last one (11) plus 5, and then this last one (16) plus 8, and then it starts again: 24+3, 27+5, 32+8...
Thanks
…
Added by Jesus Galvez at 5:17am on November 27, 2012
7, 9, 12 and 13 to be able to rotate freely around the y axis at nodes 2, 3, 6, 7, 10 and 11 respectively. The last 2 conditions, for elements 12 and 13, doesn't give any problems, but the first 4 does.
Any help?
…
in the desired order.
0 = 0
1 = 1
2 = 6
3 = 7
4 = 8
5 = 9
6 = 12
7 = 13
8 = 2
9 = 3
10 = 4
11 = 5
12 = 10
13 = 11
Where the first number is the index and the second number is the actual sorting key. Then you sort these keys while sorting your curves in parallel using the A input of the Sort component.
--
David Rutten
david@mcneel.com
Poprad, Slovakia…
David's past 2 to the 12
then me 2 to the 11 ( I need a life)
I'd say you're a shoo-in for 3rd with 2 to the 10
After that it gets a bit hazy, probably Luis then Giulio. But who's counting :)