I have created a voronoi geometry on a multi curved surface. My next step is move the initial cells in a way so i can loft the initial ones with the moved.
The moved cells (before being lofted with the initial ones) are distorted according to a set of attractor points. My aim is to create an obvious variation of the sizes of the lofted cells according to the attractors' distortion, and what i have so far is approximately the same size cells.
The result of the size variation is not that obvious and I don't know what i should do differently..
If anyone has any idea, it would be very much appreciated!
Kangaroo
3008 members
Description
THIS FORUM IS NO LONGER ACTIVE. PLEASE POST ANY NEW QUESTIONS OR DISCUSSION ON:
https://discourse.mcneel.com/c/grasshopper/kangaroo
The discussions here are preserved for reference, but new questions posted here are likely to go unanswered.
Kangaroo is a Live Physics engine for interactive simulation, optimization and form-finding directly within Grasshopper.
Morph multicurved surface voronoi cells with attractor points
by Dione
Jun 18, 2018
Hi everyone!
I have created a voronoi geometry on a multi curved surface. My next step is move the initial cells in a way so i can loft the initial ones with the moved.
The moved cells (before being lofted with the initial ones) are distorted according to a set of attractor points. My aim is to create an obvious variation of the sizes of the lofted cells according to the attractors' distortion, and what i have so far is approximately the same size cells.
The result of the size variation is not that obvious and I don't know what i should do differently..
If anyone has any idea, it would be very much appreciated!
Thanks a lot!