algorithmic modeling for Rhino

Karamba3D Discussions (751)

Sort by:

Discussions	Replies	Latest Activity
Intersectiom Joints Hi Guys! Im trying to find out which dimensions are needed for that construction. At each intersection point I shatterd the Lines and made… Started by Lukas G	3	May 29, 2017 Reply by Karamba3D
arbitary cross section Hi I want optimize cross sections of a dome with cross over elements, but the cross section I want apply to model isn't usual (as you can s… Started by shabnam lotfian	3	May 22, 2017 Reply by Karamba3D
Conversion from principal stress/force to global coordinates Hi all, I am trying to get the stresses of a shell in the global directions (e.g. X and Z) instead of the principal stresses. Is there a w… Started by Simon Clavelin	2	May 16, 2017 Reply by Simon Clavelin
Mesh loads: point load generation and meshing issues Hi all! I am working on a structure composed entirely by shells; therefore I mostly use the mesh load component to generate equivalent poi… Started by Simon Clavelin	2	May 15, 2017 Reply by Simon Clavelin
buckling in ThII Hi, I've drawn a truss and supported it in the top chord perpendecular on the plane (Ty and Rx, global buckling) but in some combinations… Started by Cansu Cirak	2	May 5, 2017 Reply by Cansu Cirak
Two curve truss structure model Hi, I’m trying to make a Karamba model of a roof based on a conic surface like the one in the picture. The structure consists of a pair of… Started by Borja Martínez	2	May 3, 2017 Reply by Borja Martínez
Material selection Hello, I have just installed the new karamba version 1.1.0, but I am facing a problem with the Material selection, I think something went… Started by Ibrahim	2	May 3, 2017 Reply by Mehran Roozbahani
MeshLoad to LineLoad Hi. I am trying to analyse a simple planar beam structure. I want to apply a surface load as lineLoads on each beam element. But when using… Started by Rasmus Holst	10	Apr 26, 2017 Reply by Balazs Kisfali
Structural Analysis of Minimal Surface Form I have a mesh that I've produced on Grasshopper, I'd like to use Karamba as a tool for structural analysis and finding where the weak point… Started by Leonardo Ali	1	Apr 25, 2017 Reply by Karamba3D
How to make a program and check how much heavy the helix bench can support? Hello everyone: How to make a program by using the karamba and check how much load the helix bench can support? It's mean that how much wei… Started by ma qingsong	0	Apr 24, 2017