algorithmic modeling for Rhino
Sort by:
Discussions | Replies | Latest Activity |
---|---|---|
Collide/Pull Surface utilizationSorry if this is covered elsewhere, if so please point me to the right spot. How is the collide surface module used with Kangaroo? Does i… Started by Chris Chalmers |
2 |
Mar 7, 2011 Reply by Daniel Piker |
Trying to model anActuated Tensegruty moduleHello, i'm trying to model a small module allready modeled by andrew payne: http://www.liftarchitects.com/journal/2007/2/22/adaptive-tenseg… Started by Carlor |
2 |
Mar 3, 2011 Reply by Carlor |
Trouble with Grasshopper 8.05I'm not sure whether this is a problem unique to me, but after updating to the newest release of grasshopper my Kangaroo tools stopped work… Started by Mike Weller |
1 |
Mar 2, 2011 Reply by gabriel |
Tensile with sticksCan someone help, this was an example file in kangaroo 3 but now i can't figure out where to plug in the "sticks" ? thanx ivan Started by Ivan Kiryakov |
2 |
Feb 28, 2011 Reply by Ivan Kiryakov |
vertical wooly paths HELPI'm trying to create attractions between paths, I think it is because Im a beginner in kangaroo/grasshopper, but Im getting an error in a… Started by JORGE LUIS TREVIÑO GARZA |
1 |
Feb 28, 2011 Reply by Christoph Degendorfer |
distorted catenary by one point-mass (specific load)hi all, i´m trying to achieve a simply distorted catenary, adding mass to a specific point of the catenary. The problem is that when the… Started by j.j. sendra |
5 |
Feb 25, 2011 Reply by Vicente Soler |
Arduino, FireFly + Kangaroo, why do I get this error? SOLVEDHi! I'm moving a Kangaroo anchor point with a slider (x value) and it's working fine. When I replace the slider with values from FireFly (A… Started by Mårten Nettelbladt |
1 |
Feb 23, 2011 Reply by Mårten Nettelbladt |
Deformable humandefinition attached below :) Started by Daniel Piker |
5 |
Feb 20, 2011 Reply by Chris Wilkins |
Evil EmpireFYI, from the "A" word... http://labs.autodesk.com/utilities/nucleus/ Started by taz |
2 |
Feb 14, 2011 Reply by robert cervellione |
Conform CurvesHi, I have been trying to create a simple interaction in Kangaroo where a circle would collapse around a series of arbitrary lines or clos… Started by Glenn Edwards |
7 |
Feb 11, 2011 Reply by Glenn Edwards |
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by