uv correspondance problem

i am trying to create lines between two surfaces but although the process is the same the uv start point in the grid of the upper surface is not the corresponding to the one on the lower surface and the lines are intersecting each other and not parallel. Could anyone help me with how this is happening and how to solve it?
thanks!

Replies to This Discussion

Permalink Reply by taz on October 25, 2010 at 1:15pm

Try flipping one of your surfaces...

Even then your lines will not end up being perfectly vertical or parallel. If that is what you're trying to do you could start with your points on one surface and obtain a vertical intersection with the other.

Permalink Reply by idtasos on October 25, 2010 at 1:22pm

i tried nothing happens. The uv distribution remains exactly the same. Just the normals have been flipped. The intersection solution seems ok and i will try it but how can i rearrange at will the uv points on a surface? for instance how can i specify the uv point that will be the starting point ?

Permalink Reply by idtasos on October 25, 2010 at 3:34pm

and the thing is how to connect uv points to uv points (surface to surface) ?

Permalink Reply by idtasos on October 25, 2010 at 3:45pm

i solved it! the mistake was the reversed order by which i choose the curves to form the 2 lofted surface.

thanks

RSS