Grasshopper

algorithmic modeling for Rhino

Surface voids

Attached is a definition i am attempting to model I would like the large organic curve areas to remain voids after lofting all the lines..is this possible?

Views: 879

Attachments:

Replies to This Discussion

Permalink Reply by Michael Pryor on December 2, 2012 at 2:35pm

not really possible with my definition :)

Permalink Reply by shaun on December 2, 2012 at 2:40pm
Arrrrrr ok more time at this I did use Galapagos to get a few variations which was pretty cool

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service