algorithmic modeling for Rhino
plane between offset
Hello people,
I'm trying to make a plane in between two curves (offset and trimmed) and try to match it to a point attractor.
Basically I want the edge offsets the least when it is the closest to the point.
The problem I am facing is when I put the point at the centre of the shape, the plane works fine (using either loft or ruled surface component) but when I move the point to a other place the plane does not work as I wanted it to be.
I am not sure what is the problem. I have attached images of the problem and the files.
Any help will be greatly appreciated. Cheers.
Views: 373
- Attachments:
-
-
Plane between offset.3dm, 30 KB -
Plane between offset.gh, 15 KB
-
Replies to This Discussion
-
Permalink Reply by Pieter Segeren on
-
Hi Aslan, I think you want to use BoundarySurface (Surface > Freeform tab) instead of the RuledSurface:
-
-
Permalink Reply by Aslan Adnan on
-
Hi Pieter, thank you so much! it works like a charm!
-
-
-
You're welcome Aslan. I simplified the definition a bit - hope you can follow the logic I thought was logical...
- Attachments:
-
-
AttrPtOffset_PSG.gh, 27 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Recrusive Split
Added by Parametric House 0 Comments 0 Likes
-
Table Field
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
