Grasshopper

algorithmic modeling for Rhino

Kangaroo Forces

Hi again,

I have just started using  kangaroo today and I keep running into trouble. I have been trying to construct a mesh and subdivide it utilising one of the Weaverbird recursive subdivision algorithms and explode explore the forces provided by Kangaroo.

This is an image of what i would like to achieve:

Views: 1178

Attachments:

Replies to This Discussion

Permalink Reply by Chris Hanley on December 29, 2014 at 4:33pm

You're definition was practically there.  For this affect, you will need to assign anchor points, (either through some selection logic or manually assigning points within the mesh).  Screen shot of the definition below just added some anchor points manually.  Daniel also builtin a utility called "springs from mesh" that does a bit of the leg work for....well....creating springs from a mesh.

Also, try applying the WB subdivision options after the kangaroo component.  applying some catmull-clark subdibivsion after the picture frame can be kind of interesting as well.

Permalink Reply by Diana Darmina on December 29, 2014 at 6:49pm

Hi,

Thank you so much for your response.

It worked perfectly and I have played around with colours as well.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service