Grasshopper

algorithmic modeling for Rhino

Hi! 

I edited the post to asking you a few tips, you know recycling and stuff. (So, the answer of  Hannes Löschke is to a previous question, now deleted)

I'm trying to place a Planar surface on differents points, but i want that the point  could be the centroid/center of the planar surface not its origin?.

Is it possible?

Views: 453

Attachments:

Reply to This

Replies to This Discussion

:B

Assuming, you either know how to create a hyp-par Surface in GH or know how to reference a hyp-par surface from Rhino, there are several components to generate a regular UV-grid. One is Divide Surface.

I suggest, you start off by reading the grasshopper primer.

Thanks. I'm new on Grasshopper, and well, i've got ton of questions. 

And yeah, i used a 4PtSrf, and then Isotrim, and is working very well.

Thanks again for the reccomendation, i did not know about the existence of that book. :3

I edited the post to asking you a few tips, you know recycling and stuff. (So, the answer of  Hannes Löschke is to a previous question, now deleted)

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service