How do I change the y value on a collection of points?

Hi, simple question

I have a series of center points that are based on a surface, that I would like to flatten(set y to 0). How would I do this?

Thanks

Joseph

Permalink Reply by Michael Pryor on September 13, 2011 at 1:02pm

Project to plane

Permalink Reply by Joseph on September 13, 2011 at 1:05pm

Thanks Michael

Permalink Reply by Pieter Segeren on September 13, 2011 at 1:37pm

Hi Joseph, decomposing the points and leaving the y value disconnected when recomposing the points seems a bit faster (in my case that is).

Permalink Reply by Michael Pryor on September 13, 2011 at 1:40pm

your right, not noticeable with few points but with many it could be make or break.

Permalink Reply by Joseph on September 13, 2011 at 6:24pm

Thanks,

Michaels way worked(i'm just starting to learn grasshopper so my definition is very simple) but I will look into this method for future use.

About

Scott Davidson created this Ning Network.

Welcome to
Grasshopper