Grasshopper

algorithmic modeling for Rhino

So I have an undulating hexagonal pattern, I'm looking to distort the pattern on a surface.  I've enclosed the file below.  I'd like it to basically map a mesh and the by changing the mesh control points be able to distort the pattern.

thanks,

Views: 3832

Attachments:

Replies to This Discussion

Hi Liam,

Really nice pattern.
How do you want to distort the pattern?
Do you want to follow the mesh/surface?
What input would the control points of the mesh would have?

Cheers

Evert
I want to have the hexagon patterns to map to a surface then the control points(on the surface) to distort the pattern i already have. I'm not even sure if this is possible, I might have to start from the beginning of the definition and rewrite the logic. The problem is matching a surface's control points to a hexagons.
Hi Liam,

It is possible, Have a look at the enclosed this is similar to what you want!

I'll have a look at it later as I need to go out.

Cheers

Evert
Attachments:
I like the definition. For my own however, I was looking for a distortion similar to this.
Attachments:
Hi,

Please look at the enclosed, this can be a start. You need to rebuild the target surface and move its control points to change the pattern.

Cheers

Evert
Attachments:
I'm curious....where did you find those pictures?

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service